No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5910-00-814-8508
NSN 5910-01-415-0273
NSN 5935-00-999-9143
NSN 6135-01-545-6582
NSN 6220-01-478-2782
NSN 5990-00-503-3264
NSN 5990-01-471-7858
NSN 6130-01-606-1199
NSN 6135-00-826-4798
NSN 6610-01-100-3662
NSN 5920-00-495-6663
NSN 6320-00-925-0558