No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5935-01-271-7548
NSN 5920-01-171-7477
NSN 5950-01-432-0137
NSN 5975-01-487-4379
NSN 6645-01-139-0156
NSN 6145-01-193-1561
NSN 4140-00-020-1835
NSN 6135-01-529-8523
NSN 5996-01-289-0493
NSN 6320-01-204-2922
NSN 6320-01-543-3238
NSN 2925-00-756-8510