No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5915-00-943-8530
NSN 5990-00-728-8248
NSN 5930-00-837-0161
NSN 2925-01-400-2286
NSN 5996-00-805-6523
NSN 5905-01-168-3915
NSN 5920-01-106-7898
NSN 6610-01-428-7779
NSN 6620-01-094-6549
NSN 6610-00-174-6709
NSN 6620-01-048-4145
NSN 5965-01-299-8690