No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6110-01-204-0000
NSN 5985-01-182-4941
NSN 6610-01-503-2254
NSN 5925-00-361-8836
NSN 5855-01-359-5727
NSN 6685-01-228-5332
NSN 5965-01-448-1757
NSN 2925-00-833-9466
NSN 6110-00-183-7788
NSN 5895-01-630-6618
NSN 6150-01-188-7859
NSN 6240-01-163-2813