0.210 in. Diameter lube hole, 3.125 in. From 1st end
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5960-00-421-1054
NSN 5930-01-577-0582
NSN 6650-00-927-3391
NSN 5855-00-629-5343
NSN 5835-00-482-0924
NSN 2925-00-623-3103
NSN 6105-01-305-9118
NSN 6145-00-079-7378
NSN 5965-01-322-3271
NSN 6685-01-429-0240
NSN 6130-01-278-5737
NSN 6135-01-471-2803