Both ends have no. 1 center 0.078 in. Dia; gear 0.556 in. Lg, 0.166 in. From second end, 14 teeth, involute, press angle 20 deg., pitch diameter 0.2187, 0.250 o.D., diametral pitch 64
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5915-00-812-6476
NSN 5996-01-052-4027
NSN 6110-01-444-1688
NSN 5835-01-023-8733
NSN 2925-00-301-0933
NSN 5835-00-422-1441
NSN 6650-01-127-9518
NSN 5945-01-321-4226
NSN 7035-01-281-3642
NSN 6610-01-633-8931
NSN 6610-00-382-0266
NSN 7035-01-537-2644