No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5920-00-225-9984
NSN 7035-01-296-4737
NSN 5990-00-488-1091
NSN 5915-00-864-7178
NSN 5960-01-227-5245
NSN 5975-01-085-6979
NSN 6150-01-028-1760
NSN 6150-01-320-8495
NSN 6320-01-532-7491
NSN 5999-01-649-8811
NSN 7035-01-380-6538
NSN 5998-00-276-2039