No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6150-00-244-5044
NSN 5910-00-829-0577
NSN 5950-00-044-2429
NSN 5950-00-961-0166
NSN 5935-01-214-8954
NSN 5985-01-134-1627
NSN 6620-01-420-8666
NSN 5950-01-264-9978
NSN 5996-01-406-7584
NSN 5905-01-066-0772
NSN 7035-01-647-9698
NSN 5910-01-467-8340