No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6150-00-631-6641
NSN 5950-00-012-3219
NSN 6145-01-148-5448
NSN 6610-00-111-7312
NSN 5999-01-651-2227
NSN 5920-01-425-0949
NSN 5855-00-879-7245
NSN 6610-01-261-1781
NSN 5895-01-463-8513
NSN 5895-00-263-0755
NSN 7035-01-383-6549
NSN 7035-01-378-5074