Second end taper; first end offset from center of end 0.458 in.
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5915-01-071-8517
NSN 5975-01-157-9432
NSN 5930-01-087-8673
NSN 6145-00-504-5221
NSN 5965-01-597-0922
NSN 5965-00-899-0453
NSN 5895-00-296-3116
NSN 6130-01-536-2509
NSN 6620-00-760-4332
NSN 6220-00-121-7541
NSN 6110-01-256-7693
NSN 6685-01-040-5752