No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Army 
U.s. Marine Corps 
Dept. of the Navy Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6135-01-215-1245
NSN 5998-01-012-7123
NSN 5960-00-630-6630
NSN 6130-00-218-1363
NSN 6110-01-606-1136
NSN 6150-01-390-7366
NSN 5915-01-489-0722
NSN 6685-01-390-7634
NSN 5945-01-649-1372
NSN 6110-01-641-2922
NSN 6645-01-459-7788
NSN 5985-01-210-0501