No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 7035-01-276-0355
NSN 5895-01-462-2764
NSN 6110-01-583-8032
NSN 6610-01-445-5274
NSN 6150-01-487-1003
NSN 5998-00-054-6895
NSN 6130-00-166-7934
NSN 5996-00-779-8349
NSN 5998-00-100-3401
NSN 5855-01-174-2463
NSN 5998-00-157-0804
NSN 6220-00-111-3188