No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5930-00-357-6096
NSN 5855-01-600-0003
NSN 5965-01-161-8097
NSN 5935-00-707-0531
NSN 4140-01-448-9725
NSN 5905-01-392-3091
NSN 7035-01-160-4423
NSN 5999-00-996-7251
NSN 5950-00-945-9984
NSN 6320-01-323-7565
NSN 5985-01-062-0675
NSN 5998-01-256-8765