No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5996-01-257-9027
NSN 7035-01-204-9851
NSN 5925-00-186-8669
NSN 5935-01-380-9010
NSN 6320-01-352-8084
NSN 5920-00-180-4278
NSN 5910-01-425-5191
NSN 5910-01-624-0649
NSN 5965-01-572-9399
NSN 6145-01-645-0111
NSN 5985-01-238-5740
NSN 5998-01-354-7217