A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6130-00-413-4683
NSN 4140-01-195-2070
NSN 5990-00-959-2514
NSN 7035-01-469-5854
NSN 2925-01-411-4666
NSN 6110-01-306-9235
NSN 4140-01-634-0330
NSN 5910-00-261-3413
NSN 7035-01-471-7648
NSN 5910-00-081-6159
NSN 5835-00-409-8355
NSN 5925-01-434-6212