No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6145-01-277-1173
NSN 5999-01-167-7522
NSN 6620-01-302-1537
NSN 6110-00-592-7474
NSN 5965-01-143-9577
NSN 6130-01-197-0213
NSN 5990-00-033-8128
NSN 5930-01-538-2816
NSN 5895-01-318-7658
NSN 6135-01-326-2536
NSN 5996-00-284-9711
NSN 6240-01-160-8499