A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Army 
Dept. of the Air Force 
Defense Threat Reduction Agency 
U.s. Marine Corps 
Dept. of the Navy 
Federal Aviation Administration 
U.s. Coast Guard 
National Aeronautics and Space Administration
National Aeronautics and Space Administration
National Aeronautics and Space Administration
National Aeronautics and Space Administration
National Aeronautics and Space Administration
National Aeronautics and Space Administration 
Austria 
Finland 
Lithuania 
Slovenia 
Poland 
Romania 
Bulgaria 
U.s. Postal Service - Procurement and Supplies Dept. 
Brazil 
Spain 
Columbia 
Israel 
Singapore 
Kuwait 
Morocco 
Saudi Arabia 
Malaysia 
Thailand 
Australia 
Belgium 
Canada 
New Zealand 
France 
Germany 
Republic of Korea 
United Kingdom 
Philippines 
Netherlands 
Portugal 
Italy 
Denmark 
Norway 
Greece 
Turkey 
NATO Maintenance and Supply Agency Classification: Washers other than lock washers, iron or steel
NSN 5985-00-811-2441
NSN 5985-01-470-1440
NSN 6645-01-337-8292
NSN 5975-01-025-5794
NSN 7035-00-794-0792
NSN 5930-01-055-5525
NSN 6220-01-491-8938
NSN 5915-01-567-8298
NSN 5965-01-464-0220
NSN 5905-00-184-7794
NSN 7035-01-068-5077
NSN 5895-01-371-0570