No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6650-01-145-5173
NSN 7035-00-206-6123
NSN 5945-01-090-0890
NSN 5945-00-615-9218
NSN 5895-01-070-5061
NSN 6220-00-501-2867
NSN 5920-00-070-8465
NSN 5950-01-165-3001
NSN 6610-01-585-2222
NSN 5960-01-245-6088
NSN 6240-00-489-8531
NSN 6650-01-111-2036