Hole off center
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6220-01-278-9369
NSN 6620-01-026-1776
NSN 2925-01-182-0227
NSN 5910-01-313-8394
NSN 5998-01-077-7671
NSN 5915-00-604-9711
NSN 5855-01-556-7421
NSN 5925-00-186-8669
NSN 6220-00-498-2424
NSN 5975-01-350-4067
NSN 6145-01-441-2252
NSN 6620-00-426-6884