A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 2925-01-197-7864
NSN 5990-01-512-9129
NSN 5915-01-410-6838
NSN 5998-00-862-5511
NSN 5998-01-442-7743
NSN 5905-00-056-3783
NSN 5930-00-411-7628
NSN 5835-01-464-7038
NSN 5998-01-543-0146
NSN 5950-01-052-1266
NSN 6130-00-359-2747
NSN 5945-01-392-1068