No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5925-01-394-1073
NSN 5975-01-396-0052
NSN 5910-00-251-7710
NSN 5996-00-347-7216
NSN 5990-01-042-8524
NSN 7035-01-011-3760
NSN 6150-01-365-1720
NSN 5996-01-622-0076
NSN 6130-00-900-4758
NSN 5990-01-433-1471
NSN 4140-01-282-6748
NSN 6685-01-476-6465