No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5835-00-289-9080
NSN 6240-01-091-8663
NSN 5855-01-308-0955
NSN 5965-01-319-5363
NSN 5975-00-276-7559
NSN 4140-01-142-3192
NSN 5910-00-379-2349
NSN 6130-01-485-3287
NSN 5905-01-377-7597
NSN 6650-01-633-9147
NSN 5855-01-580-1520
NSN 6110-01-435-6462