Hwasher has 40-50 degree angled tab at smaller end at approximately 0.530 inches from center of washer hole diameter. Tab has one 0.062 inch diameter wire hole located at approximate center of the tab.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6220-01-378-5496
NSN 5998-00-571-7611
NSN 6130-00-596-9565
NSN 5915-01-156-5703
NSN 5998-01-251-1541
NSN 5990-00-552-1611
NSN 5965-01-220-0529
NSN 6135-01-608-3470
NSN 5950-01-189-1371
NSN 6650-01-415-3332
NSN 5935-00-554-9244
NSN 5945-00-723-5832