Smaller end of washer is tabbed back 40-50 degrees beginning at 0.940 inches from washer center hole
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5965-00-959-4910
NSN 6135-01-265-1384
NSN 5895-01-437-8127
NSN 5915-01-596-8573
NSN 5996-00-779-0835
NSN 6650-01-632-1574
NSN 6685-01-576-9843
NSN 5985-00-981-0213
NSN 5996-00-806-1566
NSN 5935-01-359-1999
NSN 5950-01-203-6874
NSN 5930-01-573-7510