A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5910-01-100-5743
NSN 6130-00-444-2119
NSN 5965-01-429-6726
NSN 5975-01-494-0577
NSN 6240-01-286-6808
NSN 5950-01-312-9095
NSN 5945-00-348-0662
NSN 6130-00-025-9448
NSN 5855-01-497-0467
NSN 5935-01-107-8953
NSN 5975-01-494-1993
NSN 2925-00-428-6349