For 100wpx models only; evinrude/johnson outboard motors
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6685-01-284-6229
NSN 5910-01-442-8191
NSN 5935-01-113-3021
NSN 6145-01-359-4148
NSN 5895-01-512-9851
NSN 5920-01-599-9293
NSN 6685-01-546-1569
NSN 4140-01-018-2038
NSN 5925-01-190-6719
NSN 5950-00-799-1557
NSN 5965-01-422-1392
NSN 5915-01-423-8561