No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5835-01-152-9483
NSN 6110-00-095-3896
NSN 6610-01-381-3181
NSN 5915-01-140-3783
NSN 5950-01-027-0695
NSN 7035-01-158-8860
NSN 5835-00-302-5296
NSN 4140-00-962-0215
NSN 5998-00-495-4728
NSN 5996-01-645-4831
NSN 5965-00-594-3115
NSN 7035-00-490-0485