No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5835-01-432-6185
NSN 5925-01-178-5210
NSN 5905-00-890-5739
NSN 5920-00-204-8125
NSN 5920-01-324-3743
NSN 6130-01-254-3934
NSN 5835-00-905-7165
NSN 5905-01-435-6023
NSN 6150-01-515-7214
NSN 6105-01-381-9238
NSN 6135-01-421-7168
NSN 6240-01-235-8281