A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5945-00-466-3748
NSN 5996-01-338-5256
NSN 5945-01-013-7211
NSN 5990-01-633-9503
NSN 5905-01-525-4989
NSN 6320-01-549-7201
NSN 6145-01-279-9678
NSN 5910-01-092-7611
NSN 6610-01-024-1459
NSN 5998-01-283-1015
NSN 5945-01-373-2575
NSN 5975-01-094-5237