Two holes drilled through 0.125 in. Min 0.129 in. Max diameter 180 degrees apart one hole located 0.469 in. From washer centerline one 0.659 in. From washer center line
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5855-01-125-9167
NSN 6610-00-230-1810
NSN 5905-00-708-7569
NSN 5950-01-611-0083
NSN 5996-01-495-2714
NSN 5930-00-161-1763
NSN 5925-01-423-7197
NSN 2925-00-442-6702
NSN 5990-00-132-6430
NSN 5975-01-601-0689
NSN 5996-01-493-2705
NSN 6145-00-286-9588