Lusterless gray no. 36231 federal standard 595
No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5965-01-411-9933
NSN 5990-01-546-1649
NSN 5985-00-203-1200
NSN 5990-00-578-8850
NSN 6645-01-580-9570
NSN 6620-00-469-1179
NSN 6240-01-337-8401
NSN 6150-00-918-7139
NSN 5910-01-605-1469
NSN 5965-01-513-9978
NSN 6105-01-329-6775
NSN 5915-01-056-5141