Has hole through 0ff center 6.15 millimeters
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6220-01-044-0708
NSN 5945-00-083-6778
NSN 5910-00-332-0130
NSN 5965-01-277-8589
NSN 5945-00-553-0496
NSN 6110-01-138-5626
NSN 5996-01-213-3894
NSN 4140-00-239-9174
NSN 5996-00-150-0288
NSN 6650-01-495-0995
NSN 6650-01-145-3731
NSN 5905-00-431-0637