No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5925-00-847-7725
NSN 5895-00-446-3988
NSN 6645-00-816-5337
NSN 5985-01-149-5342
NSN 5930-00-399-7798
NSN 5985-01-198-8299
NSN 6685-01-206-4226
NSN 2925-01-113-6904
NSN 6240-01-323-4266
NSN 5998-00-920-4340
NSN 5915-01-029-3740
NSN 6150-00-453-3137