No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6220-01-164-7654
NSN 5998-00-249-2872
NSN 6620-00-538-8746
NSN 6105-01-440-9444
NSN 6150-01-440-6490
NSN 5930-00-876-9179
NSN 7035-01-191-2822
NSN 5905-01-135-8084
NSN 2925-01-493-3245
NSN 5960-00-557-6951
NSN 5990-01-421-5342
NSN 5835-00-148-9719