No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6620-01-452-8418
NSN 2925-01-660-0669
NSN 6220-00-176-0273
NSN 6110-00-984-4273
NSN 6150-01-062-2404
NSN 5998-01-152-1221
NSN 6645-00-244-0359
NSN 5960-01-328-8248
NSN 5990-01-287-1682
NSN 6150-01-525-8617
NSN 5910-01-361-8864
NSN 5895-01-411-7127