No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 2925-01-468-7073
NSN 6145-01-192-0738
NSN 5925-00-760-6350
NSN 7035-01-422-5297
NSN 5935-01-312-6664
NSN 6620-00-335-9462
NSN 7035-01-449-1189
NSN 6220-01-419-1932
NSN 5960-00-275-7497
NSN 5920-01-459-3863
NSN 5895-01-352-5695
NSN 6150-00-900-8128