No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 4140-01-436-9831
NSN 5835-01-553-6772
NSN 6150-01-573-8913
NSN 5905-01-303-0677
NSN 4140-01-135-4617
NSN 5895-01-172-3203
NSN 5835-01-632-6627
NSN 4140-01-125-5187
NSN 5835-00-469-3395
NSN 6685-01-420-7407
NSN 5996-01-414-1685
NSN 5920-00-621-6601