No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5950-00-720-2706
NSN 6110-00-308-3993
NSN 5930-01-067-9131
NSN 6240-00-227-0135
NSN 4140-01-587-5620
NSN 6150-01-291-6389
NSN 6145-01-033-2805
NSN 6150-00-276-7483
NSN 6240-01-275-4535
NSN 5855-00-688-9954
NSN 5915-01-436-6259
NSN 6220-01-228-5390