1st end center drill 0.11-0.08 diam; 2nd end 0.400 diam w/ two more holes on both sides, 0.155 inches from end
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5835-00-433-0170
NSN 5915-01-410-7822
NSN 5855-01-381-6052
NSN 5910-01-101-6038
NSN 5920-01-314-7231
NSN 6685-01-323-1975
NSN 5950-00-277-4439
NSN 5935-00-753-7279
NSN 5905-00-235-5401
NSN 6320-00-115-0883
NSN 5990-01-507-7495
NSN 6240-00-243-8336