1st end chamfer 0.03 by 45 deg, 2nd end 0.01 by 45.0
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6320-01-610-4410
NSN 5925-00-677-8320
NSN 5965-01-617-5557
NSN 6110-00-679-8961
NSN 5915-01-605-9068
NSN 6220-00-511-3934
NSN 6645-01-362-2587
NSN 5990-01-047-4083
NSN 2925-01-570-3690
NSN 6110-01-290-4759
NSN 6650-01-293-5557
NSN 6105-01-495-0623