No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6240-01-428-9410
NSN 6110-01-325-8943
NSN 4140-01-278-1310
NSN 6610-01-331-6966
NSN 5910-00-734-7234
NSN 2925-01-276-6100
NSN 6135-01-386-5709
NSN 5835-01-514-5758
NSN 6620-00-905-6590
NSN 6320-01-481-7322
NSN 5835-01-262-6561
NSN 5895-01-225-3333