No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6240-01-485-6728
NSN 6240-01-144-1334
NSN 6130-01-219-7007
NSN 5915-00-265-0967
NSN 6110-00-239-9248
NSN 6110-00-412-2305
NSN 6620-01-203-1022
NSN 5910-01-222-0769
NSN 5950-01-062-6912
NSN 4140-01-297-5148
NSN 5935-00-594-7793
NSN 5835-01-158-6878