No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5910-01-633-9963
NSN 5975-01-263-3280
NSN 5998-01-489-5309
NSN 5985-01-202-7919
NSN 6650-01-158-6577
NSN 5950-01-162-6346
NSN 4140-01-428-9426
NSN 5960-01-487-6436
NSN 5945-01-084-4638
NSN 5905-00-456-0662
NSN 5950-00-906-1396
NSN 7035-01-619-1268