Drill 0.140 in. Hole 0.975 in. Min to 0.995 in. Max from center
No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5990-01-261-2962
NSN 5855-01-201-4857
NSN 5960-01-609-6565
NSN 6645-01-260-7426
NSN 5965-00-471-5018
NSN 5905-01-019-9651
NSN 5895-00-363-1486
NSN 5905-01-475-4459
NSN 5998-01-648-8145
NSN 6135-01-550-6279
NSN 2925-00-233-5644
NSN 5950-01-412-4539