No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 7035-01-072-0611
NSN 5998-00-289-9092
NSN 5960-01-214-4518
NSN 5910-00-203-5373
NSN 5930-01-320-7885
NSN 5965-01-572-2787
NSN 6135-00-242-9531
NSN 5945-00-661-0506
NSN 5855-01-020-7982
NSN 2925-01-090-2391
NSN 6620-01-185-9134
NSN 6150-00-238-6204