One large bolt hole 0.813 in. Dia, 2 smaller holes countersunk 100 degrees, bottom right corner bevel length along width 0.420 in., bottom right corner bevel length along length 0.500 in.; thickness is 0.250 in. For 1.500 in. Then 0.625 in. For remaining 2.190 in.
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use disk, solid, plain. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see shim. For items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes gasket; insulator (as modified) and mounting pad, electrical-electronic component.
Classification: Other articles of iron or steel not wire nesoi
NSN 5895-00-707-6663
NSN 6645-01-386-6311
NSN 5855-00-922-6459
NSN 5835-01-466-5496
NSN 6685-01-180-0261
NSN 6650-00-575-7487
NSN 5910-01-468-7408
NSN 5930-01-544-1283
NSN 2925-01-417-6815
NSN 6145-01-626-5756
NSN 5935-01-612-3765
NSN 5990-00-212-4316