No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5999-00-354-4613
NSN 6645-00-716-8049
NSN 5855-01-587-6166
NSN 5915-00-238-0328
NSN 2925-00-491-3549
NSN 5855-01-379-3160
NSN 5990-01-164-8673
NSN 6105-01-074-5369
NSN 6645-01-295-4373
NSN 4140-01-304-2950
NSN 5910-00-200-9096
NSN 6150-01-025-6305