No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6240-01-382-3756
NSN 5999-00-260-0471
NSN 6110-01-525-2223
NSN 6620-00-766-3974
NSN 5910-00-216-8081
NSN 5915-01-478-3376
NSN 5999-00-289-1472
NSN 5895-01-305-1328
NSN 6620-01-012-2852
NSN 6150-00-016-3785
NSN 6220-00-228-7791
NSN 5965-01-111-0983