No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5960-00-826-7697
NSN 6610-01-192-2467
NSN 6145-01-201-2320
NSN 5965-01-622-6982
NSN 5996-00-821-8136
NSN 6645-01-271-0248
NSN 6685-01-588-8901
NSN 5835-00-829-0670
NSN 5855-00-058-1293
NSN 5990-01-037-9801
NSN 5998-01-406-5746
NSN 5999-00-093-0403