No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 2925-00-511-0325
NSN 6135-01-633-8502
NSN 6150-00-486-8448
NSN 5925-00-054-0100
NSN 5945-01-373-3820
NSN 5905-01-487-5744
NSN 6685-01-328-8909
NSN 5985-00-442-9430
NSN 5915-00-333-8569
NSN 5935-00-399-2617
NSN 5925-01-029-3483
NSN 5905-00-734-6303